Relay Module
with LED
(Fully Assembled PCB)
Product Use
This 5 VDC Relay Module is especially developed for Automotive or Hobby use, allowing microcontroller to switch on any high current load.
Command Signal of low current at low voltage (Typically 1 milliAmpere @ 3 V to 12 V DC) into the Relay Module electronically switches ON a Higher current Load (up to 10A) at typical automotive system voltage (10 VDC to 14.4 VDC).
In constant ON applications it can carry up to 10 Ampere load.
The 5 VDC Relay Module can be used to switch on AC loads up to 250 VAC, such as lights, fans, motors and other devices ON/OFF while keeping them isolated from the microcontroller.
The LED located on the PCB is ON when the Input Pin (#1) is connected to Positive Voltage that has a Common Ground with the Module.
Control Input can be connected directly to any output pin of PARALLAX PROPELLER microcontroller without need for any resistors.
The 5 VDC Relay Module is Arduino Compatible.
Features
- Control Relay Module with a simple high/low Command signal
- Input ON Monitoring LED
- Nominal Voltage 5V
- Operating / Releasing Time ≤ 1 ms / ≤ 1 ms
- Over 100,000,000 Electronic Cycles Life
Connections
INPUT
- CIN = ON Command Signal 3.3 VDC to 12 VDC +
- Vbb 5 VDC +
- GND (Common System Ground)
OUTPUT
- Relay NC = Normally Closed Contact
- Relay C (Common Input)
- Relay NO = Normally Open Contact
Product Specifications
| Relay Coil source voltage (min/max) | VDS | 5 | V |
| Relay Coil load current (max) | IL | 10 | A |
| Command Signal Voltage (min/max) | VC | 3 / 12 | V DC |
| Command Signal Voltage (recommended) | VC | 3.3 to 5 | V DC |
| Power Consumption (LED) | Pon | 160 to 210 | mW |
| Operating Temperature | Ton | 20 to 140 -6 to 60 |
°F °C |
| Module Size | 44 x 27 x 18 | mm |
Module Circuit Diagram
Pricing
US $5.00 each