Injector Driver
(Fully Assembled PCB)
Product Use
This Injector Driver is especially developed for Automotive use, allowing microcontroller to switch on common automotive Fuel Injectors with 12 VDC coils.
Command Signal of low current at low voltage (Typically 1 milliAmpere @ 3 V to 5 V DC) into the Injector Driver electronically switches ON a Higher current Load (up to 6A) at typical automotive system voltage (10 VDC to 14.4 VDC).
The Injector Driver is intended to switch on Automotive Fuel Injectors that are used in Gasoline fueled engines.
Features
- Control Automotive Fuel Injectors with a simple high/low Command signal
- Nominal Voltage 12V
- Operating / Releasing Time ≤ 1 ms / ≤ 1 ms
- Over 100,000,000 Electronic Cycles Life
Connections
INPUT
- Vbb 12 VDC +
- ON Command Signal 3.3 VDC to 5 VDC +
- GND (Common System Ground)
- Vcc 5 VDC +
OUTPUT
- To Injector + = Vbb 12 VDC +
- To Injector - = Driver ON (Switched to GND)
- GND (Common System Ground)
Product Specifications
| Injector Coil source voltage (min/max) | VDS | 8 / 16 | V |
| Injector Coil load current (max) | IL | 6 | A |
| Command Signal Voltage (min/max) | VC | 3 / 6 | V DC |
| Command Signal Voltage (recommended) | VC | 3.3 to 5 | V DC |
| Operating Temperature | Ton | 20 to 140 -6 to 60 |
°F °C |
Pricing
US $25.00 each